Digi ConnectPort Network Device Guia do Utilizador descarregar pdf (Página 105)

105

Configuration through Simple Network Management Protocol (SNMP)

Configuring ConnectPort LTS products through Simple Network Management protocol uses a

subset of standard MIBs for network and serial configuration, plus several Digi enterprise MIBs for

device identification, alarm handling and ConnectPort LTS products specific configurations. These

MIBs are listed and described under ―Configuration Interfaces,‖ and must be loaded into a network

management station (NMS). The standard and Digi Enterprise MIBs allow for very basic network

and serial configuration. For more detailed configuration settings, use the command-line interface

or web interface instead.

Some elements of SNMP configuration can only be configured from the web interface or command

line, such as the setting to send alarms as SNMP traps. In the web interface, this setting is located at

Configuration > Alarms > alarm > Alarm Destinations > Send SNMP trap to following

destination when alarm occurs. See "Alarms.‖ In the command-line interface, this setting is

configured by the set alarm option type=snmptrap. See the set alarm command description in the

ConnectPort LTS Command Reference.

For more information on SNMP as a device interface, see ―Configuration Interfaces.‖ For

information on SNMP as a monitoring interface, see ―Monitoring Capabilities from SNMP.‖

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 148 149

Sem comentários

Digi ConnectPort Network Device Guia do Utilizador Página 105